Troubleshooting, Specifications – MMD Equipment IGR3000 User Manual

Page 19

Advertising
background image

MMD PowerPro Inverter Generators • IGR3000 (041715)

MMD PowerPro Inverter Generators • IGR3000 (041715)

Page 36

Page 37

Engine will not start

Problem/Possible cause

Corrective action

No fuel in tank

Refuel with gasoline

Fuel switch not on

Turn fuel switch to ON position

Not enough oil in engine

Refill with recommended oil

Fuel not reaching carburetor

How to check:

1. Turn off fuel valve and loosen drain screw

2. See if fuel is flowing from drain when fuel valve is turned

on.
If the engine still does not start, please take the generator

to an authorized dealer.

No spark from spark plug

Check spark plug or replace spark plug

How to check spark plug:

1. Remove spark plug cap and clean any debris off sparkplug.

2. Remove spark plug and install spark plug in the plug cap.
3. Set the plug-side electrode on the cylinder head to the ground.

4. Pull the recoil starter. Sparks should jump across plug gap.

If the engine still does not start, please take the generator to an authorized dealer.

Appliance does not operate

Problem

Corrective action

Output indicator not on

Check appliance/equipment for defects

Overload indicator on

1. Replace appliance/equipment, or have repaired.

2. Stop and restart engine and try again.

If still not operational, please take the generator to an authorized dealer.

No power to the DC receptacle

Problem

Corrective action

DC circuit fuse blown

Replace fuse

If still not operational, please take the generator to an authorized dealer.

10. Troubleshooting

Make sure there is no spilled gasoline around spark plug. Spilled fuel may ignite.

11. Specifications

Model

IGR3000

Rated Output, watts

2800

Rated Current, amp

23.3

Maximum Output, watts

3000

Phase

Single

Parallel operation allowed

No

Maximum Current, amp

25.0

AC Voltage

120

Frequency, Hz

60

DC Output

12V @ 5A

HP @ rated RPM

5.36 @ 3600

Starting System

Recoil/Electric

Engine Type

Air cooled, single cylinder, 4-stroke, OHV with

electronic ignition

Displacement, cc

196

Compression Ratio

8.5:1

Ignition System

Transitionized

Spark Plug

WR7DC

Fuel

Regular unblended automotive gasoline

(87-octane)

Lube Oil

SAE 10W30 (see viscosity chart)

Oil Capacity - qt. (L)

0.63 qt. (0.6L)

Noise Level, no load-full load, dB @ 23

ft.

63-73

Rated load continuous run time, hrs.

8

Fuel tank capacity, gal.

3.4

Dimensions, LxWxH, in.

27.5 x 17 x 19.9

Dry Weight, lb.

132.3

Receptacles

125V GFCI 20A; L5-30R 125V T-Lock 30A

Tune Up Specifications

Spark Plug Gap

0.028 – 0.031 in. (0.7-0.8 mm)

Valve Clearance (Intake)

0.0039 ± 0.0008 in. (0.10 ± 0.02 mm)

Valve Clearance (Exhaust)

0.0059 ± 0.0008 in. (0.15 ± 0.02 mm)

Advertising
This manual is related to the following products: