MMD Equipment 400S-6B1 - Manual (Page 21)

4. Operation
4-2
4.2 Door
4.2.1 Open/Close the Door
Keep the door closed and locked while running the unit.
When the door has to be opened, be careful not to touch
portions that are rotating or very hot.
Careless touch may cause serious injury.
PK0028
Pull the handle forward to open the door.
Be sure to close the door tightly so that its latch is firmly caught.
4.3 Check before Starting Unit
Check before starting the unit
Be sure to check the unit before operation.
When any abnormality is found, be sure to repair it before restarting the unit.
Be sure to make daily checks before operation. If the unit is operated without prior check and without
noticing its abnormality, such operation could cause seizure of components or may even cause fire.
4.3.1 Check Engine Oil Level
Unit should be on level before checking oil level.
When you check oil level after you have once started operation, wait 10 to 20 minutes after
stopping engine, before checking the oil level.
(Procedure)
①
Pull out the engine oil dipstick, and wipe it with a clean
cloth.
② Then, re-insert the dipstick fully and pull it out again. If
the dipstick shows the oil level between MIN and MAX, it
is normal.
③ When the oil level is below its MIN, add engine oil.
(See 5.6.1)
While checking oil level, check also for contamination. If the
oil is found dirty, contaminated or should it be changed
according to the periodic inspection list, change the oil.
(See 5.6.1)
A000166
MAX
MIN