Monster iCarPlay Wireless 1000 - Manual (Page 6)

Using AutoScan 3D ™ Automatic
FM Frequency Selection (recommended)
The iCarPlay Wireless 1000 features AutoScan 3D to
automatically find the best, clearest FM channel in your
local area. Remember that as you drive through different
areas the FM signal conditions change, so when driving
long distances, you can repeat the AutoScan 3D
selection whenever FM interference occurs.
1. Press and hold the bottom “S” (scan) button until the
LCD screen begins scanning. The iCarPlay Wireless
1000 will rapidly scan the entire FM spectrum three
times, to ensure the best possible signal.* The LCD
will then display the frequency that AutoScan 3D
has selected. Tune your car radio to that frequency.
NOTE: After using AutoScan 3D, the selected
frequency will be automatically stored to the
“S” button’s memory for instant recall.
2. Tune your FM radio to the same channel.
LCD Screen Timer Settings
Press and hold the D (display) button to change the
LCD illumination between Auto-Off, which will turn the
display off after a few seconds, and ON which leaves
the display on until the unit is unplugged.
* Depending on variable environmental factors
(OLD
THE
TO
!UTO3CAN