Installation, Installing the log set, Removing and installing the door – Montigo B34DV User Manual
Page 16: Ositioning the og et
Page 16
B-Series DV-2 Gas Fireplace
Part No. XG0160 -141231
Installation
Installing the Log Set
Installing the Logs:
The B-Series DV2 is supplied with five ceramic fibre logs. Unpack the
logs and handle them very carefully.
1. Remove the door cover and the glass door.
2. Place the Back log onto the back log rest as shown below in figure
29. The log has a lip on the bottom which fits into the slot on the
log rest.
3. Place the Front log onto the front log rest as shown in figure 29.
Center the log from side to side, and push it against the back of the
log rest. Carefully push the log onto the metal spikes on the log rest.
4. Place the top logs in position as shown in figure 29a, place the
centre log down first, then the right and left logs.
5. Start the fireplace. If the flame appears satisfactory, replace the
glass door and door cover.
Figure 29. Positioning for the front and back logs.
Figure 29a. Proper log placement.
Removing and Installing
the Door
Removing the door:
Remove the trim (as described in the next column) to access the door
latches. Open the latches by pulling Part A upwards and towards you
to disengage Part B from the door. Lift Part B clear of the door. Repeat
.l
la
f
t
o
n
s
e
o
d
ti
o
s
yl
lu
f
e
r
a
c
r
o
o
d
e
h
t
dl
o
h
o
t
e
r
u
s
e
B
.s
e
h
ct
al
h
t
o
b
r
o
f
Figure 28b. Removing and installing the glass door.
Figure 28a. Removing and installing the glass door.
Figure 28c. Removing and installing the glass door.
Re in t ing the door:
o re install the door tilt the top edge towards you and line up the tabs
far as it will go. lose the latches by hoo ing Part B onto the groove at
the top of the door and pushing Part A down completely.
ositioning the og et
n t ing the og :
are resting on the log rests and are not covering the burner ports. he
a tions
f logs are not placed properly excessive sooting will
result.
he surface of the logs will crac due to the heat of the
n
n
n t ing the og :
The 6 horizontal trim pieces (3 upper and 3 lower) are purchased separate
nstall the trim by placing the top edge of the trim over to the retainer
below.
he trim piece with the ontigo mblem should be installed on the lower
middle clips with the emblem on the right side.
Figure 29. Installing the Trims.