Montigo HFK50R - Manual

Fan Kit
Installing the HFK50R Fan Kit for Proflame 2
Page 1 XT0015 - 092214

This kit should be installed by a qualified person.

Check local codes and read all instructions prior to installation.
Ensure that all power to the appliance is off at the electrical breaker or fuse
before beginning installation. Ensure gas is turned off at the shutoff valve before
beginning installation.
CAUTION
For use with:
H*34-DF/DL; L38-DF
H*38-DF/DL; L42-DF
H*-DF/DL; L52-DF
* = C, L, P, R, W
General Information
This blower kit is for installation with the models listed above.
Installation
1. Remove burner tray if required.
®
C US
Before You Begin
Ensure that the power supply has been turned off at the breaker or
fuse before beginning the installation.
Shut off the gas supply at the shut-off valve, and ensure that the main
burner and pilot light have been turned off and the fireplace has been
cooled off for at least two hours before installation.
KIT # Contents
HFK50R 2x blowers, 1x fan cord assembly, 4x mounting screws,
Velcro strips, self-adhesive cable tie mounts and cable
ties.
HFK50R Required: This fan kit requires one of the remote control
kits (PF2 Remote Kit or RX 100*) for proper operation.
Burner Tray Gasket
17
Figure 1 Contents of HFK50R Fan Kit package.
18
Burner Tray Gasket
Figure 2 Removing the burner tray (L38DF, L42DF, L52DF
models only).
Figure 3 Removing the burner tray (L38DF, L42DF, L52DF
models only).
Left fan Right fan
Fan wire harness
Cable ties &
mounts
Fan mount-
ing screws