Montigo HFK50 - Manual

Fan Kit
Installing the HFK50 Fan Kit for Proflame 2
Page 1 XT0014 - 092214

This kit should be installed by a qualified person.

Check local codes and read all instructions prior to installation.
Ensure that all power to the appliance is off at the electrical breaker or fuse
before beginning installation. Ensure gas is turned off at the shutoff valve before
beginning installation.
CAUTION For use with:
H*34-DF/DL; L38-DF
H*38-DF/DL; L42-DF
H*-DF/DL; L52-DF
* = C, L, P, R, W
General Information
This blower kit is for installation with the models listed above.
Installation
1. Remove burner tray if required (follow instructions in the fireplace
installation manual).
®
C US
Before You Begin
Ensure that the power supply has been turned off at the breaker or
fuse before beginning the installation.
Shut off the gas supply at the shut-off valve, and ensure that the main
burner and pilot light have been turned off and the fireplace has been
cooled off for at least two hours be fore installation.
KIT # Contents
HFK50 2x blowers, 1x fan cord assembly with heat sensor
switch, Fan Speed Controller with Dual Receptacle
(DRB001), 4x mounting screws, Velcro strips,
self-adhesive cable tie mounts and cable ties.
Burner Tray Gasket
17
Figure 1 Contents of HFK50 Fan Kit package.
18
Burner Tray Gasket
Figure 2 Removing the burner tray (L38DF, L42DF, L52DF
models only).
Figure 3 Removing the burner tray (L38DF, L42DF, L52DF
models only).
Left fan Right fan
Dual Recep-
tacle control box
(DRB001)
Fan Harness Power Cord
with heat sensor
Cable ties &
mounts Fan mount-
ing screws