Motion Sound KP-200S - Manual (Page 4)

4
<100 Hz Output
¼ unbalanced, 300 mv rms, 12 db oct @ 100 Hz. This output is used for bass or sub-woofer
augmentation of the KP-200S, such as with a Motion Sound SW-15 Subwoofer. Set the bass control
on the KP-200S at 5 or lower and let your external bass amplifier handle the lows. The KP-200S will
then have full power available for mid and high frequencies. Using the 100 Hz output does not disable
those frequencies from the KP-200S.
Maintenance
Finish: A tough Polymaric
™ polymer finish. Clean with mild soap and water if needed. No other
maintenance is necessary.
Speakers: Remove screws from the grill cover and remove the grill. The 10” speakers and horns are
mounted from the front with screws into steel inserts. Wires from the amplifier to the 10” speakers
and ferro cooled dynamic horns are removable spade types. If you change speakers, use 8 ohm only.
Amplifier: The entire amplifier chassis is mounted from the rear outside. Remove all screws on top
and around the back of the amplifier chassis. You must remove the speaker wires from the front
(remove 10” speaker first) before the amp chassis can be entirely removed.