Mr. Coffee BVMC-SJX33GT - Manual (Page 11)

5. Turn the coffeemaker off and let stand for 30 minutes.
6. Run the remainder of the cleaning solution through
the coffeemaker.
7. Discard the cleaning solution and rinse the decanter
thoroughly with clean water.
8. Fill the water reservoir with clean, fresh water.
9. Place the empty decanter back on the coffeemaker,
centered on the warming plate.
10. Remove and discard the paper filter used during
the cleaning cycle. If a Mr. Coffee ® permanent filter
was used during cleaning, remove it and rinse it
thoroughly before replacing it in the filter basket.
11. Begin brewing and allow the full brew cycle to complete.
12. Repeat steps 8 through 11 one more time.
Suggested Decalcifying Interval
The frequency of cleaning depends on the hardness
of the water used. The following table gives a suggested
cleaning schedule.
20 21
Water Filtration Disk Replacement
Your water filtration disk will need to be replaced
once a month (approx. 30 brew cycles). If the machine
will not be in use for an extended period of time,
rinse the water filter with running water and clean the
coffeemaker before use.
Cleaning the Decanter
Hard water can leave a whitish stain on the decanter,
and coffee may then turn this stain brown.
To remove decanter stains:
1. Fill the decanter with a solution of equal parts
water and vinegar and let the solution stand in the
decanter for approximately 20 minutes.
2. Discard the solution, then wash and rinse the
decanter.
NOTE: Do not use harsh abrasive cleaners that may
scratch the decanter, scratches may cause the decanter
to break.
Type of Water
Soft Water
Hard Water
Cleaning Frequency
Every 80 Brew Cycles
Every 40 Brew Cycles
BVMC-SJXGT_12ESM2.indd 21-22 9/11/12 10:53 AM