Museum Technology Source DVD-204-BR Control for Pioneer BluRay - Manual (Page 3)

Select POWER ON START and change the set-
ting to ON Continue on to the BAUD RATE item and
select 9600 bps
This completes the player setup. The next step is to program the DVD-204-BR such that each pushbutton
plays the desired content.
Figure 3 Figure 4
PROGRAMMING THE DVD-204-BR
Using the supplied PROGRAMMING CABLE connect the DVD-204-BR to the serial port (9 pin connector) on
a Windows PC. Start a terminal program such as Hyperterm and configure it as follows:
Direct connection (as opposed to modem)
9600 Baud
1 Stop Bit
No Parity
Handshaking: None
Press the red PROGRAM button on the rear panel of the DVD-204-BR and the following should appear on
the PC’s screen:
Museum Technology Source
323 Andover St.
Wilmington, MA 01887
Phone: (800)729-6873 or (978)657-3898
Fax: (978)657-7132
Email: [email protected]
------- Main Menu -------
A - select address mode (TIME or CHAPTER)
B - view or edit a Button's selection
I - view or edit the Idle selection
T - Test the buttons and lamps
O - go to Options menu
Please choose a command:
Press A to select addressing by TIME or
CHAPTER. This is a global setting affecting
all further programming.
Press B to select a button to edit
Press I to set the players action when not
playing in response to a button push
Press T to test buttons and lamps. Pressing a
button will cause it to light up and the button
number will appear on PC’s screen
O go to options menu