Olson Technology S450P Series - Manual (Page 8)

025-000485 REV x1 Page 8
3.4 Input Channel Tuning
(continued)
The last four positions of switch 2 (Figure 3-2) are used for band selection. The first four positions of switch 2 and
all of switch 1 are used for tuning within the selected band.
Set the Input Channel switches for the channel to be tuned as indicated in Table 3-1 (for VHF or cable channels) or
Table 3-2 (for UHF channels). In the table a “1” indicates that the switch is set to the “up” (or “on”) position, a “0”
indicates that the switch is set to the “down” (or “off”) position.