DigiTech RP255 - Manual (Page 44)

38
Section Four - Other Functions
Phrase Looper
The RP255 features a built-in 20 second Phrase Looper for creating on the fly performance loops
of the music you play. The Phrase Looper can be accessed any time during performance and used
with any of the RP’s presets.
To use the Phrase Looper, follow these steps:
Press and hold the left 1. Down Footswitch for 2 seconds until LOOPer appears in the dis-
play. The Looper LED will also light in the matrix indicating the Looper is active.
Arm the Phrase Looper to record by pressing the 2. Down Footswitch again. The display will
read ArMeD meaning it is ready for you to start playing (You can also start recording immedi-
ately when this footswitch is pressed).
Begin playing a phrase on the guitar. The Phrase Looper will begin recording anything that is 3.
played. The display will read reCorD.
Once you are ready to set the loop point, press any footswitch. The display will briefly read 4.
PLAY and the recorded phrase will now begin playing back.
To add an overdub to the looped phrase, press and hold the left 5. Down Footswitch. The
display will read OVrDuB. While holding the footswitch, begin playing the overdub phrase to
be added to the loop. When the Down Footswitch is released, the display will briefly flash
PLAY and the looped phrase will continue with the newly added overdub phrase added.
To stop the Phrase Looper, press and release the left 6. Down Footswitch quickly. You can
resume playback by pressing this footswitch again.
To clear a recorded loop, stop the loop playback first as outlined in step 6 and then press and 7.
hold left Down Footswitch for 2 seconds until the display read CLeArD.