Pacific Cycles REACH Rear Suspension maintenance - Manual (Page 2)

Note: Apply the grease on a regular basis to make the suspension working at its best.
9
Put the PU unit back.
10
Tighten the stop screws back with 2mm allen key.
11
Assemble the nut and washer at the end of the
suspension and anodized tube.
12
Reverse the order in Step 3 and 2, tighten the
washers and nut back with the 13mm deep
socket.
13
Thread eyelet end into the tube body until the
distance between the center of the holes at
each end is approx.
120mm, then tighten the
two hexagonal bots
inward by 32mm open
wrench.
14
Done. Assemble the suspension to the bike frame.
120mm