Permasteel PG-4030000L - Manual (Page 14)

12
Usage:
1) Read instructions before lighting.
2) Open the lid during lighting.
3) Simply place a lighted match between the coils on the end of the lighting
rod and hold next to the burner to ignite.
4) Push and turn the knob to “ ” position, make sure the burner lights
and stays lit.
5) Repeat steps 3-4 to light other burners.
6) Keep a spray bottle of soapy water near the gas supply valve and check
the connections before each use. Do not light the grill if odor of gas is
present, and call our service center.
ƒ FLAME CHARACTERISTICS:
1) Check for proper burner flame characteristics. Each burner is adjusted prior to
shipment; however, variations in the local gas supply may take subtle necessary
adjustments.
2) Burner flames should be blue and stable with small yellow tips, with no excessive
noise, or lifting. If any of these conditions exist call our customer service line. If
the flame is yellow, it indicates insufficient air. If the flame is noisy and tends to
lift away from the burner, it indicates too much air.
3) Small yellow tips are ok.
GRILL LIGHTING INSTRUCTION
OPERATING INSTRUCTION
!!! CAUTION !!!
ƒ Clean the grill often. A grease fire that may damage the grill may occur if the grill
has not been cleaned frequently.
ƒ NEVER leave the grill unattended while using.
ƒ Do not use water to extinguish the grease fire, it may cause bodily injury.
Turn knobs off and tank off in case grease fire occurs.
ƒ Grease fire can’t be put out by closing the lid. Turn off knobs and tank
IMMEDIATELY if any grease fire occurs.