Posiflex SD-666W - Manual (Page 2)

Page 2 / 2
2. DRIVER INSTALLATION
1.
For iButton reader: The configuration of the iButton reader can be programmed through
Hyper Terminal function at the COM port that the DB9 type cable of SD-660/SD-666 is
connected to. The reader can be programmed to output through the USB port (connected
with the conversion cable) as an USB KB or through RS232 interface as the application
software requires. Please enter the “Hyper Terminal” function on KS system and select the
COM port. Type fully capitalized “SETUP” and press “enter” key. All available
configuration parameters will then be presented
2. For MSR: The magnetic stripe reader in SD-660/SD-666, no matter how many tracks are
in the reader head, connects to the host through the proprietary internal USB port working
as a USB KB and therefore requires no driver installation. For application in OS other than
Windows (such as MS-DOS or Linux), some technical internal modifications will be
required and it is most advised to specify such conditions clearly when ordering the SD-
660/SD-666. For application of MS-DOS model please also enable the USB keyboard in
system CMOS setup. Refer to “Operation Guide” for manipulation over the reader
configuration.
III. OPERATION GUIDE
1. iBUTTON READER
Each iButton receptor is delivered with 2 iButton keys attached. Each iButton key carries
a unique ID. Whenever the user places an iButton key to the reading area of the iButton reader,
the key will stick to the reader by magnetism and the unique ID will be sent to the KS system
through USB or RS232 interface as preprogrammed. Please approach your dealer for purchase
of any additional iButton key required.
2. MAGNETIC STRIPE READER
For magnetic stripe card reading, be sure to insert the card to the bottom with magnetic
stripe facing the mark aside the slot. The movement of the card can be either inserting the card
from the top surface then sliding the card down out of the slot, or sliding the card upward from
the lower side of the slot till it reaches the top end as long as the card is a standard one. A non-
standard card recorded without complete degaussing prior to recovery may accept only one
direction in card reading.
The MSR in SD-660/SD-666 reads an ISO or JIS magnetic stripe card without driver.
Yet, there is a “Posiflex USB MSR Manager” program provided to control some parameter
configuration for ISO MSR. The features controllable in this program covers: each track
enable/disable, Alt+Num approach for ASCII codes and Leading/Stop code enable/disable.
The function for enabling each track of course comes in effect only when the track is
physically available. Please find in the Product Information CD delivered with KS system the
folder “\Drivers\SD_Series\USBMSR_xxx” and “SetUp” this manager program or download
the installation program from our web http://www.posiflex.com or http://www.posiflex.com.tw.
警告使用者 警告使用者 警告使用者 警告使用者
這是甲類的資訊產品，在居住的環
境 中 使 用 時 ， 可 能 會 造成 射 頻 干
擾，在這種情況下，使用者會被要
求採取某些適當的對策。
T31454