Posiflex LM-3010F - Manual (Page 12)

Part 12
C. OPENING PLASTIC NECK COVER
To route through base, please observe the below side view pictures of
the base trunk and release the triangle marked hooks to remove the
plastic neck cover.
D. CABLE ROUTING IN BASE
For cable routing in the mini slim base, please refer to the picture
below. Have all cables pass through the oval hole on the trunk as
triangle marked to come out of the arrowed cable exit hole on the
base rear side of trunk. Then connect all the cables ends to main unit.
LM/TM-3010/KS for KS Series
Please do the following steps to install LM/TM-3010/KS:
Step A): Fasten the 4 screws onto the upper rear
bracket of KS series machine.
Then Hold the LM-3210/KS monitor
with bracket, aim to join the upper rear
bracket then fasten the 3 screws onto the
indicated holes.
Step B): Connect the VGA Cable to the LM VGA port and route the VGA
cable through the cable exit hole of KS base stand to the system
VGA port on the I/O plate.