Posiflex LM-3010F - Manual (Page 13)

Part 13
LM/TM-3010/HS for HS Series
To mount LM-3010/HS on the back of the terminal, please do the following
steps to tilt LCD panel:
Step A): Release the top cover on the HS system top I/O plate.
Step B): Adjust the rear bracket of 2
nd
display to its adequate angle, connect
one VGA cable end at the 2
nd
display VGA port, the other at the VGA
port on the top I/O plate by routing thru the cable exit hole.
Apply carefully the 4 small screws that come along with the 2nd
display series to the back of this terminal at the screw hole circled in
the below picture.
Step C): Close the rear bracket cable cover as illustrated.
A) B)
C)
Note: Do not overdo the tightening or unrecoverable thread damage will
occur.
LM/TM-3114/3114-B/3115/3115-B Series
A. TILTING LCD PANEL
Please do the following steps to tilt LCD panel:
Step A): Hold and push downward the main unit indicated