Proel NEOS152PX - Manual (Page 3)

REAR PANEL
INPUT - External amplifi er power input. The signal is fi ltered by a passive crossover. The connec ons depend by the confi gura on se ngs
accordingly the following table:
INPUT
FULL RANGE BI-AMP
1+ / 1- INPUT 1+ / 1- LOW
2+ / 2- INTERNALLY N.C. 2+ / 2- HIGH
LINK - Power signal output, to connect the unit to another speaker. The INPUT and LINK connectors are parallel to each other.
PRODUCT LABEL - In this label are wri en the most important data informa on about the passive loudspeaker, model, impedance, maximum
applicable con nuous power, serial number.
FULL RANGE / BI-AMP MODE - The speaker system can operate both in FULL RANGE and BI-AMP mode:
In FULL RANGE mode a built- in crossover fi lter allows the loudspeaker to be powered by a single amplifi er.
The BI-AMP mode requires a dedicated amplifi er for each speaker (woofer and HF driver), even if the internal crossover is not excluded we
recommend the use of an external crossover or processor before the amplifi ers.
The mode selec on can be done by an internal jumper (see fi gure 1), which can be accessible by removing the rear connec on plate. The factory
se ng is FULL-RANGE mode.
FIGURE 1: TO SET THE LOUDSPEAKER AS BI-AMP,
REMOVE THE REAR PANEL, LOCATE THE JUMPER AND
MOVE IT IN THE OTHER SIDE OF THE CROSSOVER
CIRCUIT.