PSE Archery TAC 2013 - Manual (Page 17)

CROSSBOW OWNER’S GUIDE CROSSBOW OWNER’S GUIDE
®
17
4. Inspect cams and cables to assure that the cables are in
proper orientation to the Reference Marks on the cams
(Figure 22.) The cables need not be in perfect alignment
with the Reference Marks but they must match from cam
to cam. If the Reference Marks are out of alignment an
authorized PSE dealer can make the adjustment.
5. If rotating the loop on the string does not seem to make
any difference in the direction of the tear, the following
procedure can be used:
First, center the loop on the string relative to the barrel.
This can be referenced using the groove down the
center of the barrel. After centering the loop shoot
through paper again. If the tear is nock left, place one
half twist in the bottom right split harness. If the tear
is nock right, place one half twist in the bottom left split
harness.
NOTE:
Make adjustments in one half twist increments
until the arrow tears through the paper straight.
Fig. 22
Reference Mark