REMKO TX 3000 - Manual (Page 5)

5
Ventilation
In this position only the supply air fan runs. The thermo-
static regulation and the heating operation is not possible.
Attention, important hints to the after-cooling phase
◊ The air supply fan continues running to cool down
the unit and then stops later.
Fan can start several times before final switching off.
◊ Never interrupt (except in emergency situations) the
connection to the mains before the end of the whole
after-cooling phase.
Unit Shut Down
Heating
The unit runs fully automatically and is dependent on
set temperatures.
If the temperature at the blower aperture rises above
80° C the heating operation is stopped and will restart
after the cooling-down period automatically.
1. Put operating switch into position “0”.
OFF.
1. Pre-select desired room tem-
perature on the room thermo-
stat.
2. Put operating switch into position “I”.
Heating
1. Put operating switch into position “II”.
Ventilation
Please carry out an electrical safety test after hav-
ing finished service on the unit.
0
40
OFF
Extension cables may only be used once they are
unrolled.
Our guarantee does not cover damages caused to
the unit by overheating.
Maintenance
Regular maintenance and the observation of some ba-
sic principles is important to ensure a long service life
and a trouble-free operation of the unit.
Please pay attention to the following points:
◊ The unit is to be maintained and cleaned in regular
intervals.
◊ The unit is to be kept free from dust and other de-
posits and is to be cleaned only with a dry or humid
cloth.
Do not use water jet.
◊ Do not use any aggressive cleaning agents or those
which are harmful or environmentally unfriendly.
◊ Do not use cleaning agents which contain solvents.
◊ Only use suitable cleaning agents to remove ex-
treme dirt.
◊ Check safety devices regularly.
Check protective suction and blower grids regularly
and clean, when necessary.
◊ Do not damage the sensor and capillary tube of the
thermostat when the rear panel is installed or re-
moved.
◊ According to the terms of use the units are to be
checked as to their perfect operation by an expert
when necessary, but at least once a year.
Prior to starting any work make sure to pull the
mains plug out of the mains socket!
Correct usage
The units are to be used only for heating and ventilation
purpose in industrial or commercial application because
of their construction and equipment. If specification of
the manufacturer or legal regulations, are not followed
or if unauthorised changes are made on the unit, the
manufacturer is not liable for resulting damages.
An operation/use other than that indicated in these
instructions is prohibited!
In the case of non-observation we will not be held
responsible and our guarantee will become void.
Service and Guarantee
Any claims under guarantee regarding materials can be
accepted only when the orderer or his customer has
filled in completely the “guarantee certificate” which is
enclosed with every REMKO-heater and has returned it
to REMKO GmbH & Co. KG in due time after the unit’s
sale and commissioning. The units are factory tested on
faultless function. If any failures occurs though which
cannot be eliminated by the operating person, please
contact your dealer or contact person.