REMKO DN 40 - Manual (Page 8)

8
REMKO
3-WAY SWITCHING VALVE DN 40
Manual mode
The 3-way switching valve can
be operated manually until the time
of commissioning or in case of a defect
of the actuator. The electrical actuator
must be removed in this case.
! CAUTION
The replacement of the actuator
must take place in a de-energised
(electrical) state. Also disconnect
the main connection to the actuator.
To do so, proceed as follows:
1. Loosen the union nuts of the
actuator. These can be found under
the white actuator. Then you can
simply remove the actuator.
2. Screw on the delivered plastic cap
in the appropriate position, to set the
desired position.