REMKO FBR-2 - Manual (Page 4)

4
REMKO FBR-2
ANALOGUE REMOTE CONTROL
WITH ROOM SENSOR
Carefully read the operating instruction
before placing the equipment in service.
It contains useful tips and notes
such as hazard warnings to prevent
injury and material damage. Failure to
follow the directions in this manual can
result in endangerment to persons, the
environment and the equipment itself
and will void any claims for liability.
■ Keep this manual in the vicinity of
the unit.
■ The setup and installation of the
unit and its components should only
be undertaken by an authorised
specialist.
■ The set-up, connection, and operation
of the unit and its components must
be in accordance with the operating
conditions stipulated in this manual
and comply with all applicable local
regulations.
■ Modification of equipment and
components supplied by REMKO
is not permitted and can cause
malfunctions.
■ Equipment and components may not
be operated in areas where there is
an increased risk of damage. Observe
the minimum clearances.
Safety notes
■ The electrical supply is to be adapted
to the requirements of the equipment.
■ The operational safety of equipment
and components is only assured if
they are fully assembled and used as
intended. Safety devices may not be
modified or bypassed.
■ Do not operate equipment or
components with obvious defects or
signs of damage.
■ The equipment and components
must be kept at a safe distance to
inflammable, explosive, combustible,
aggressive and dirty areas or
atmospheres.
■ Installation, repair and maintenance
work may be carried out only
by authorised specialists. Visual
inspections and cleaning can be
performed by the operator as long
as power is disconnected from the
equipment.
■ To preclude any danger from
the equipment, take appropriate
hazard-prevention measures when
performing installation, repair or
maintenance work or cleaning the
equipment.