REMKO ETS300 - Manual (Page 4)

4
REMKO
ETS 300
Carefully read the operating manual
before placing the unit in service for
the first time. It provides useful tips
notes and hazard warnings to prevent
injury and material damage. Failure
to follow the directions in this manual
can endanger persons, the environment
and the equipment itself and will void any
claims for liability.
■ Keep this manual in the vicinity
of the units.
■ Only qualified personnel may
set up and install the units
and components.
■ The set-up, connection, and operation
of the unit and its components must
be in accordance with the operating
conditions stipulated in this manual
and comply with all applicable local
regulations
■ Modification of the units
and components supplied by REMKO
is not permitted and can cause
malfunctions.
■ Units and components may not
be operated in areas where there
is an increased risk of damage.
Observe the minimum clearances.
Safety notes
■ The electrical supply is to be adapted
to the requirements of the units.
■ The operational safety of units
and components is only assured
if they are fully assembled and used
as intended. Safety devices may not
be modified or bypassed.
■ Do not operate units or components
if there are obvious defects or signs
of damage.
■ The units and components must
be kept at an adequate distance
from flammable, explosive,
combustible, abrasive and dirty areas
or atmospheres.
■ Installation, repair and maintenance
work may only be carried out
by authorised specialists. Visual
inspections and cleaning can
be performed by the operator as long
as the equipment is disconnected
from the power.
■ Take appropriate precautions when
performing installation, repair
or maintenance work or cleaning
the unit to make sure the unit does
not pose a danger to persons.