REMKO ETS300 - Manual (Page 8)

8
REMKO
ETS 300
Installation instructions
for qualified personnel
General instructions prior to installation
■ Ensure that the area in which the unit
is to be operated is free of frost
and easily accessible for required
maintenance, repairs and even
for the possible replacement
of the unit (e.g. avoid overly narrow
thoroughfares and doorways).
■ When installing the tank in unusual
locations, such as in lofts, residential
units with floors that are sensitive
towater, storerooms, etc. take
account of the possibility of leaking
water, and ensure that a facility
is in place to catch the water,
including appropriate drainage
methods.
■ The unit may only be positioned and
operated on level surfaces.
■ When planning the unit's installation
surface and selecting the installation
location, note the total weight of the
tank, including the weight of the
water (the nominal capacity), in
order to ensure that the statics of
the load-bearing surface are not
exceeded.
■ Ensure proper clearance from firing
systems.
Installation should only
be performed by authorised
specialists.
Preparation of the hot water
must be in compliance with
the applicable standards.
NOTE
■ Check the contents of the packaging
for completeness and check the unit
for visible transport damage.
Immediately notify your contract
partner of any deficiencies.
■ In the selection and/or sequence
of the installation materials
used for the plant, any possible
electrochemical processes must
be taken into consideration
in accordance with the recognised
good practices (mixed-metal
installations!).
■ Make sure that units with enclosures,
which are installed in small, tight
spaces or in suspended ceilings
have the connection block (water
and electric connections and heater
installation) still freely accessible and
that there us no buildup of heat.
■ Leave at least 500mm of space
free for the removal of the heating
flange.
Assembly