REMKO WPM-Smart-Control-Manual for specialists-WKF-120 - Manual (Page 35)

Unmixed heating cycle
Optionally, you can activate or deactivate the
"Unmixed heating cycle" function. Activate the
"Unmixed heating cycle" if wall or floor heating is
installed. If there is a system separation in the
panel heating, it must also be activated (select with
the rotary knob and confirm with "OK").
Fig. 47: Activate unmixed heating cycle
Menu item Parameter Factory setting
Unmixed
heating
cycle
Deactivated
Deactivated
Activated
Press "Next".
Setting heating cycle mode
This is where you can select between the different
heating cycle modes. The choice is between con-
trol according to the set "Heating curve" and
"Fixed value control" (select with the rotary knob
and confirm with "OK").
Menu item Parameter Factory setting
Heating
cycle mode
with FB
active
Heating curve
According
to design
Fixed value 10 °C - 50 °C
Press "Next".
Heating-curve heating cycle mode
The heating curve can be adjusted in three points,
according to the structure and location-related con-
ditions of the building:
Base point:
The base point corresponds to the minimum set
temperature of the heating water at an outside
temperature of 20°C. If the heating is too cold at
relatively high outside temperatures (trans-sea-
sonal period), the base point should be set higher.
Standard inlet temperature:
the standard inlet temperature corresponds to the
set temperature of the heating water at the
standard outside temperature in the building loca-
tion. If the heating is not warm enough at low out-
side temperatures, the standard inlet temperature
should be increased.
Standard outside temperature:
the standard outside temperature is dependent on
the regional location of the building. Please consult
your heating installer.
2
1
4
3
Fig. 48: Heating curve adjustment
1: Temperature of the heating water in °C
2: Inlet temperature heating curve
3: Return flow heating curve
4: Outside temperature in °C
35