Rena EasyFeed Lite - Manual (Page 8)

ASSEMBLY AND INSTALLATION
5
Connecting Power
Plugging in the Feeder
Make sure that the Power Switch on the Feeder is OFF.
1. Connect one end of the Feeder power cord to the rear of the Feeder in the
corresponding receptacle.
2. Plug the other end of the cord into a 115 Volt AC (220 VAC International), 50/60 Hz,
grounded outlet.
CAUTION
DO NOT USE ADAPTER PLUGS OR EXTENSION CORDS TO
CONNECT THE FEEDER TO THE WALL RECEPTACLE.
DO NOT USE OUTLETS CONTROLLED BY WALL SWITCHES.
DO NOT USE AN OUTLET THAT SHARES THE SAME CIRCUIT WITH
LARGE ELECTRICAL MACHINES OR APPLIANCES.