RGBLink MSP 217 Quick Start User Manual
Quick start, View size the world, Msp 217
MSP 217 –
Quick Start
MSP 217-TX SDI to Fiber Right Panel
Signal Indicator
Power Interface
Connection
MSP 217-RX Fiber to SDI Left Panel
1
4
Remote communication device control interface, used
to connect to the computer or console.
Power Interface
USB Interface
Interface
The device uses the standard 12V/1.5A power supply.
Signal Indicator
SDI Input Interface
SDI input interface，Can receive video signal from
HD player, and HD camera, connect interface 16 via
75 ohms impedance BNC port. Connect LED screens
via network cable.
Fiber Output Interface
1
1
VIEW SIZE THE WORLD
NOTE
For full installation, configuration, and operation details, please refer to
the MSP 217 user manual, which is available at
This guide provides quick start instructions for an experienced installer
to set up and operate the MSP 217.
Address: S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone, Xiamen, Fujian Province, P.R.C
Tel: 00865925771197 Fax:00865925771202
Email: [email protected]
MSP 217 Quick Start
Rev 1.0
Page 1 of 2
5
3
6
2
SDI Input Interface
USB Interface
Power indicator 2 lights when device has power
supply.
LED indicator 4 is on when connect SDI cable and
the device is in normal Operation.
LED indicator 6 is on when connect USB cable and
the device is in normal Operation.
MSP 217-TX SDI to Fiber Left Panel
Connection
1
2
Signal Indicator
Fiber Output Interface
Signal Indicator
LED indicator 1 is on when connect fiber cable and
the device is in normal operation.
Used to connect fiber cable, the device uses single
mode one-core, LC interface.
Connection
2
Signal Indicator
Fiber Input Interface
Signal Indicator
LED indicator 1 is on when connect fiber cable and
the device is in normal operation.
Fiber Input Interface
Used to connect fiber cable, the device uses single
mode one-core, LC interface.
MSP 217-RX Fiber to SDI Right Panel
Connection
5
3
6
4
2
Power Interface
Signal Indicator
SDI Output Interface
USB Interface
Power Interface
The device uses the standard 12V/1.5A power supply.