RGBLink MSP 217 Quick Start User Manual
Page 2
SDI Output Interface
USB Interface
Function Block Diagram
Operating Principle
MSP 217 SDI to Fiber
Address: S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone, Xiamen, Fujian Province, P.R.C
Tel: 00865925771197 Fax:00865925771202
Email: [email protected]
MSP 217 Quick Start
Rev 1.0
Page 2 of 2
Common Questions and Solution
Signal Indicator
Power indicator 2 lights when device has power supply.
LED indicator 4 is on when connect SDI cable and the
device is in normal Operation.
LED indicator 6 is on when connect USB cable and
the device is in normal Operation.
SDI output interface，Can receive video signal from
HD player, and HD camera, connect interface 16 via
75 ohms impedance BNC port. Connect LED
screens via network cable.
Remote communication device control interface,
used to connect to the computer or console.
Operation Manual
MSP 217 SDI to Fiber transmitter is connected to
media player or HD/SD SDI camera, etc. MSP 217
SDI to Fiber transmitter to power supply. In order to
avoid the damage of device, please use the standard
power adapter. Fiber interface is used to connect to
MSP 217 Fiber to SDI receiver.
MSP 217 Fiber to SDI
Function Block Diagram
Operating Principle
on MSP 217 SDI to Fiber transmitter with fiber cable,
and then connect the SDI interface on MSP 217 Fiber
to SDI panel to display device.In order to avoid
damaging the device, please use the standard power
adapter.
MSP 217 Fiber to SDI receiver is connected to
television (monitor) or other device which has SDI
interface
Connect the fiber interface to the other interface
Power indicator light is off or blinks
1. Check whether plug in the power cord, and has
power supply;
2. Check whether the power cable is connected, and
in good connection;
3. If above without problem, then the power indicator
is damaged.
Signal indicator light is off or blinks
1. Check whether connect the signal;
2. Check whether the input signal, input wire and output
wire are normal, the interfaces are in good connection;
3. If above without problem, then the signal indicator is
damaged.
Note: The indicator beside fiber interface is on when the
device is in normal operation. It will off or blink if the
fiber cable is in poor connection.
12V power interface poor contact
1. Check whether the power interface is in good
connection, if the interface is not tighten, screw it again.
2. Check whether any problem with adapter head,
replace it if there is any problem.
3. Check the power connector is loose, if so, please send
to processional personnel for repair.