Dometic Elite RM7732 - Manual (Page 13)

13
(3. Troubleshooting
Continued on Page 14)
F. FUSES FUSES FUSES FUSES FUSES
The refrigerator is equipped with two fuses; one for the
refrigerator control system, and one for the AC cartridge
heat. (See Table below) To replace fuse(s), proceed as
follows:
1. Disconnect the wall plug and the 12 volt wires.
2. Remove the power module cover. See FIG. 12.
3. Snap the fuse out of the fuse holder.
4. Fit a new fuse into the fuse holder.
5. Replace the power module cover.
Control System Control System Control System Control System Control System 3-amp 3-amp 3-amp 3-amp 3-amp
AC Heater AC Heater AC Heater AC Heater AC Heater 5-amp 5-amp 5-amp 5-amp 5-amp
10) Reinstall burner, being careful that the end of the
burner fits into the slot on the burner bracket.
Check to make sure slots are centered under the
flue tube and the thermocouple is positioned prop-
erly (tip of thermocouple extends over two slots of
burner).
11) Be sure to reconnect the wire to high voltage
electrode. Check the electrode for proper location
and gap. (See FIG. 17).
12) Turn on manual gas shutoff valve and check all
fittings for leaks.
13) Connect 120 volt power cord to the outlet and
reconnect or turn on the 12 volt DC power.
14) Check LP gas safety shutoff. See Section A. Instal-
lation, Item 9. Testing LP Gas Safety Shutoff .
FIG. 17 FIG. 17 FIG. 17 FIG. 17 FIG. 17
ELECTRODE
BURNER TUB
1/8" TO 3/16"
(3-5 mm)
FIG. 16