Dometic Elite RM7732 - Manual (Page 7)

7
11. 11. 11. 11. 11. 12 12 12 12 12 V V V V VOL OL OL OL OLT DC CONNECTION T DC CONNECTION T DC CONNECTION T DC CONNECTION T DC CONNECTION
This refrigerator model is not designed for 12 volt DC
operation of the cooling system; however, 12 volt DC must
be supplied to the refrigerator to operate the controls. Use
a minimum of a 14 gauge wire between the battery and
refrigerator to supply the control voltage. The connection
is made to the positive (+) and negative (-) terminals of the
terminal block on back of refrigerator (See FIG. 12). The
12 volt DC supply circuit must be fused, and the maximum
fuse size is 5 amps.
DO NOT DO NOT DO NOT DO NOT DO NOT use the body or chassis of the vehicle as a
substitute for either of the two conductors. Do not connect
any other electrical equipment of lighting to the refrigerator
circuit.
Clean Direct Current (DC) power is mandatory for Clean Direct Current (DC) power is mandatory for Clean Direct Current (DC) power is mandatory for Clean Direct Current (DC) power is mandatory for Clean Direct Current (DC) power is mandatory for
high-tech circuits to operate as designed. The sources
high-tech circuits to operate as designed. The sources high-tech circuits to operate as designed. The sources high-tech circuits to operate as designed. The sources high-tech circuits to operate as designed. The sources
for DC power are a battery and a converter.
for DC power are a battery and a converter. for DC power are a battery and a converter. for DC power are a battery and a converter. for DC power are a battery and a converter.
A battery will provide straight line DC power, but A battery will provide straight line DC power, but A battery will provide straight line DC power, but A battery will provide straight line DC power, but A battery will provide straight line DC power, but
extended operation will require recharging of the
extended operation will require recharging of the extended operation will require recharging of the extended operation will require recharging of the extended operation will require recharging of the
battery by the converter or the alternator.
battery by the converter or the alternator. battery by the converter or the alternator. battery by the converter or the alternator. battery by the converter or the alternator.
The converter and alternator produces DC power by a The converter and alternator produces DC power by a The converter and alternator produces DC power by a The converter and alternator produces DC power by a The converter and alternator produces DC power by a
series of diodes that rectify alternating current to DC.
series of diodes that rectify alternating current to DC. series of diodes that rectify alternating current to DC. series of diodes that rectify alternating current to DC. series of diodes that rectify alternating current to DC.
A battery or capacitors can be used to clean up the AC
A battery or capacitors can be used to clean up the AC A battery or capacitors can be used to clean up the AC A battery or capacitors can be used to clean up the AC A battery or capacitors can be used to clean up the AC
ripple that is present after AC voltage has been rectified.
ripple that is present after AC voltage has been rectified. ripple that is present after AC voltage has been rectified. ripple that is present after AC voltage has been rectified. ripple that is present after AC voltage has been rectified.
12. 12. 12. 12. 12. INSTR INSTR INSTR INSTR INSTRUCTION FOR INST UCTION FOR INST UCTION FOR INST UCTION FOR INST UCTION FOR INSTALLING ALLING ALLING ALLING ALLING
DOOR P DOOR P DOOR P DOOR P DOOR PANEL ANEL ANEL ANEL ANEL
The refrigerator is delivered without the door panels.
Before starting the mounting work, check that the panel
dimensions are in compliance with those given in the Table
on this page and the instructions are read thoroughly.
When mounting the panel, proceed as follows. (See FIG.
14).
A. Open the door 90 degrees.
On new refrigerators, the decoration strips are taped
inside the door; if installed on the door, remove the door
decoration strip by removing the three screws on the
fresh food compartment door; and the two screws on
the freezer compartment door.
B. Make sure the two pins are in the end frame of the door
to support the panel. See FIG. 14.
C. Slide panel into grooves on vertical edges of the door
until it rests on the pins at the lower frame of door.
D. Replace the trim strip and screws.
PANEL DIMENSIONS
MAX. THICKNESS 5/32" (4mm)
REFR. MODEL HEIGHT WIDTH
RM7732 MAX. MIN. MAX. MIN.
Frozen Food 55-3/16 55-1/8 10-9/16 10-7/16
Compartment (1402) (1400) (268) (265)
Fresh Food 55-3/16 55-1/8 16-15/16 16-13/16
Compartment (1402) (1400) (430) (427)
SECTION B. CERTIFIED VENT SYSTEM KITS
REFRIGERATOR KIT
MODEL NO. COMPONENTS PART NO.
RM7732 OPTION #1 ROOF BASE 3103633.XXX*
ROOF COVER 3103634.XXX*
LOWER SIDE VENT 3103847.004
OPTION #3-A POWER VENT ASM. 3104131.002**
POWER VENTILATOR ROOF BASE 3103633.XXX*
(Island/through floor) ROOF COVER 3103634.XXX*
* Fill in "XXX" with color code numbers. For color codes, contact your supplier.
** Alternate instructions forwarded with the Ventilator Kit.
FIG. 14