Scotsman CU0415 - Manual (Page 26)

August 2013
Page 25
Service Manual for Models CU0415, CU0715 and CU0920
Removal and Replacement
Pump
1. Disconnect electrical power.
2. Remove top panel.
3. Remove wall panel covering pump.
4. Disconnect wires from pump motor.
5. Remove cube deflector and pull hose off water
pump outlet.
6. Rotate pump slightly CW and lift pump up and out
of the ice machine.
7. Install new pump in reverse order of the removal
steps.
Spray Platform
1. Remove front panel.
2. Shut unit off.
3. Open door, remove cube deflector by lifting it up,
twisting slightly and pulling out.
4. Pull spray platform forward unit it releases from its
snap, and remove pump hose from platform.
5. Remove platform from the unit. Replace or service
and then reinstall it.
6. Reconnect pump hose.
7. Slide platform back into reservoir.
Note: Bottom of platform has a raised area that
fits only on the left side. Be sure platform is
placed all the way back in the reservoir and is
snapped in place.
8. Reinstall cube deflector, be sure it is snapped onto
the reservoir wall.
9. Switch unit on, check spray pattern.
Wall Panel
Spray Platform Service
The two halves may be separated by removing the
clips and pulling it apart. Be sure gasket is intact and
installed correctly.