Scotsman CU0415 - Manual (Page 9)

Service Manual for Models CU0415, CU0715 and CU0920
August 2013
Page 8
Connect the power
This is a cord-connected unit, and must be connected
to its own dedicated power supply. Check the
dataplate on the back of the machine to confirm the
voltage and per the dataplate use fuses or HACR
circuit breakers.
Power Cord:
This 115 volt model is equipped with a cord and 5-15P
plug.
Follow All Local Codes - This Unit Must Be
Grounded. Do not use extension cords and do not
disable or by-pass ground prong on electrical plug.
Plug the power cord into the proper power supply.
Installation check list
• Has the machine been installed indoors in an
environment suitable for it?
• Have all of the shipping items and packaging been
removed?
• Has the plastic covering the exterior panels been
removed?
• Is the ice chute in the correct position?
• Is the clear plastic curtain hanging down and free to
move?
• Has the water supply been connected and
confirmed to not leak?
• Has a properly sized and sloped drain tube been
attached?
• Has the correct voltage power supply been
connected?
Front view of freezing compartment, right arrow points
to Spray Platform, under the Cube Deflector. Push
curtain back and check that it is in this position.
Left arrow points to Cube Deflector, it must be
positioned as shown, it snaps onto front edge of
reservoir. Remove any packing materials.
Front view of freezing compartment, arrow points to
clear plastic curtain. After checking spray platform,
pull curtain down to hang freely. This is its normal
position.
Curtain