Sierra Video 3232HD-3G - Manual (Page 7)

SIERRA VIDEO
3
Power Supply Cords
Use only power cord(s) supplied with the unit.
If power cord(s) were not supplied with the unit, select as follows:
For units installed in the USA and Canada: select a flexible, three-conductor power cord that is
UL listed and CSA certified, with individual conductor wire size of #18 AWG, and a maximum
length of 4.5 meters. The power cord terminations should be NEMA Type 5-15P (three-prong
earthing) at one end and IEC appliance inlet coupler at the other end. Any of the following types
of power cords are acceptable; SV, SVE, SVO, SVT, SVTO, SVTOO, S, SE, SO, SOO, ST, STO,
STOO, SJ, SJE, SJO, SJOO, SJT, SJTOO, SP-3, G, W.
For units installed in all other countries; select only a flexible, three-conductor power cord,
approved by the cognizant safety organization of your country. The power cord must be Type
HAR (Harmonized), with individual conductor wire size of 0.75 mm². The power cord terminations
should be a suitably rated earthing-type plug at one end and IEC appliance inlet coupler at the
other end. Both of the power cord terminations must carry the certification label (mark) of the
cognizant safety organization of your country.
A non-shielded power cord may be used to connect AC power to every component and peripheral
of the system.
Connect an external 16 AWG or larger wire from earth ground to the chassis of the system as
designated by the earth ground symbol.
North American Power Supply Cords
This equipment is supplied with North American power cords with molded grounded plug (NEMA-
15P) at one end and molded grounding connector (IEC 320-C13) at the other end. Conductors
are CEE color coded, light blue(neutral), brown(line), and green/yellow(ground). Operation of the
equipment at voltages exceeding 130VAC will require power supply cords that comply with NEMA
configurations.
International Power Supply Cords
If shipped outside North America, this equipment is supplied with molded ground connector (IEC
320-C13) at one end and stripped connectors (50/5mm) at the other end. Connections are CEE
color coded, light blue (neutral), brown(line), and green/yellow(ground). Other IEC 320-C13 type
power cords can be used if they comply with safety regulations of the country in which they are
installed.
EMC Regulatory Notices
Federal Communications Commission (FCC) Part 15 Information: This device complies with Part
15 of the FCC standard rules. Operation is subject to the following conditions:
This device may not cause harmful interference
This device must accept any interference received including interference that may cause
undesirable operations.
Delivery Damage Inspection
Carefully inspect the frame and exterior components to be sure that there has been no shipping
damage.