Sierra Video SVG Multi-Viewer - Manual (Page 15)

SIERRA VIDEO
5
Installation
Introduction
Installation procedures are similar for all frames covered under this manual. Exceptions, if
any, have been noted in each of the following paragraphs.
Rack Mounting
Carefully inspect the frame to ensure that there has been no shipping damage. Make
sure all shipping material is removed from the multi-viewer frame.
The multi-viewer described in this manual can be rack mounted in a standard 19" (RU)
EIA rack assembly and includes rack "ears" at the ends of the front of the frames. It does
not require spacing above or below the unit for ventilation.
To rack mount any the multi-viewer, simply place the unit's rack ears against the rack
rails of the rack, and insert proper rack screws through each of the holes in the rack ears.
Always rack mount the multi-viewer prior to plugging the unit into a power receptacle or
attaching any cables.
CAUTION!
The operating temperature range of this product is 0 to 40ºC. Do not exceed the
maximum (40ºC) or minimum (0ºC) operating temperature.
If installed in a closed or multi-rack assembly, the operating ambient temperature of the
rack environment may be greater than the room ambient temperature. Therefore,
consideration should be given to installing the equipment in an environment compatible
with the manufacturer’s maximum rated ambient temperature.
Installation of the equipment in a rack should be such that the amount of air flow to the
sides of the multi-viewer required for safe operation is not compromised.
Dimensions
The SVG multi viewer frame is 1 rack units high, 19” wide, and 20” deep.
Chapter 2