DeVilbiss FA752-3 - Manual (Page 9)

9 — ENG MGP-FA752-3A
Compressed air from the outfit may contain water
condensation. Do not spray unfiltered air at an
item that could be damaged by moisture. Some
air operated tools or devices may require filtered
air. Read the instructions for the air tool or device.
1. Before plugging in the air compressor, set the adjust-
able pressure valve to "10" PSI. Make sure the "ON/
OFF" switch is in the "OFF" position.
2. Connect the air tool or accessory to the air hose.
Tighten securely.
3. Plug the power cord into the grounded outlet.
4. Start the compressor by setting the "ON/OFF" switch
to the "ON" position.
5. Check the manufacturer's maximum pressure rating
for the air tool, accessory or vehicle tire being used.
The air compressor outlet pressure must never ex-
ceed the maximum pressure rating.
6. Slowly increase the pressure setting of the adjustable
pressure valve. You should be able to hear and feel
air pressure being relieved by the adjustable pressure
valve. If pressure is not being relieved, turn the air
compressor off immediately. The pressure valve must
be replaced.
TOO MUCH AIR PRESSURE COULD CAUSE AN
AIR TOOL OR VEHICLE TIRE TO RUPTURE OR
EXPLODE. CAREFULLY FOLLOW STEPS 5 AND 6
EACH TIME YOU USE YOUR COMPRESSOR.
OPERATING PROCEDURES
When you have finished using the air compressor:
1. Set the "ON/OFF" switch to "OFF" and unplug the
cord.
2. Relieve all pressure from the air compressor head and
air hose by setting the adjustable pressure valve to 10
P.S.I.
3. Drain water from air tank.
STORAGE
4. After the water has been drained, close the drain cock
or drain valve.
5. Protect the electrical cord and air hose from damage by
winding them loosely around the air compressor.
6. Store the air compressor in a clean and dry location.