SL Power Electronics GSM15 User Manual
SL Power Electronics Equipment
a subsidiary of SL INDUSTRIES, INC.
ISO 9001 CERTIFIED
6050 King Street, Bldg A
Ventura, CA 93003
Phone: 805-486-4565
Fax: (805) 487-8911
MODEL NUMBERS: GSM15-X-YYY G, where X equals 5, 12, 15, 24, or 28, -YYY is any number
000-999 which represents value added options not related to safety, and G which represents compliance
to RoHS.
RATINGS:
Input: 100-240 V ac, 0.6 A, 50/60 Hz
Output:
Model
Volts
Amps
Amps
Convection
Peak or 150 LFM
3
GSM15-5
5.1
2.35
3.0
GSM15-12
12
1.25
1.5
GSM15-15
15
1.0
1.2
GSM15-24
24
0.625
0.75
GSM15-28
28
0.54
0.64
Notes: 1.
Maximum ambient temperature for rated output power is 50°C. Storage: -40 to +85 °C.
2.
Maximum Operating Relative Humidity 96%, no condensation.
3.
Peak power for 60 seconds, 10% duty cycle, no airflow or continuous rating with 150
LFM of airflow.
CERTIFICATION: All models are Certified to be in compliance with the applicable requirements of
IEC/EN/UL 60601-1; CSA 22.2 No. 601.1-M90;.
CLASSIFICATION: (5.1) Protection against electric shock = Class I or Class II
(In accordance with
sub- clause 5 of IEC
601-1)
(5.2) Degree of protection against electric shock = Not acceptable for applied
part without additional isolation (contact factory for details)
(5.3) Protection against harmful ingress of water = Ordinary (no protection)
(5.5) Have not been evaluated for use in the presence of a flammable anaesthetic
mixture with air, oxygen, or nitrous oxide. This evaluation is to be made on the
end equipment by the OEM.
(5.6) Mode of operation = Continuous
SAFETY DECLARATION: SL Power Electronics Corp. declares under our sole
responsibility that all models listed above are in conformity with the applicable
requirements of EN60950-1 following the provisions of the Low Voltage Directive
73/23/EEC.
OUTPUTS: The output is not acceptable for patient connection without additional isolation. The DC
output is SELV under normal and single fault conditions.
OVERVOLTAGE PROTECTION: The output is monitored for an overvoltage condition. In some
applications where an overvoltage condition could result in a hazard as defined in applicable safety
standards, redundant or additional overvoltage protection may be required. Consult factory for details.
41-34957-0001 Rev. D
Page 1 of 2
GSM15 SINGLE OUTPUT SERIES
INSTALLATION INSTRUCTIONS