Smart Avi CATSwitch - Manual (Page 5)

5
www.smartavi.com
Installation
Connecting XTAV transmitter
Connecting The Transmitter
1. Connect the output of the computer video card to the video input of the transmitter using the included male
to male video cable.
2. Connecttheoutputofthecomputeraudiocardtothe audio input of the transmitter using 3.5mm audio male to
male audio cable.
3. Connectexternalspeakerstothetransmitter’saudio out (Standard 3.5mm stereo miniplug).
4. In the back of the unit connect the CAT5 cable that will connect to the receiver (XTAV-RX).
Adjusting and Tuning the Signal
In order to fine tune the signal, adjust the individual dials one at a time
starting with GREEN, then BLUE, and lastly RED. As you turn the dials you will
notice the colors slightly change as you increase or decrease the strength. All
dials should be around the same distance
Connecting the XTAV receiver
Connecting The Receiver
1. Connect CAT5 cable (coming from the transmitter) to the back of the receiver.
2. Connect display monitors to the VGA out connector on the front of the receiver.
3. Connect external speakers to the audio output connections on the front of the unit. (Standard 3.5mm stereo
Miniplug)