Smart Avi SignWall - Manual (Page 8)

8
www.smartavi.com
Quick Installation
1
2
3
4
FRONT of 2X2 Video Wall
1 1
2
IN OUT
2
3
3
4
4 1
2
3
4
EDID-Mirror-4P
SignWall
Installation Diagram
NOTE: If for some reason you need to change or reset your configuration,
follow the instructions on the following pages titled Custom Installation.
1. Connect all the DVI-D cables from the SignWall processor to the EDID-Mirror-4P and to the
Video Wall as shown in the above diagram.
2. Plug in the green ASUSBKEY to any available USB port.
3. Power on the EDID-Mirror-4P by plugging it in.
4. Power on the Displays.
5. Power on the SignWall processor.
6. Run the SignWall Manager software.
IMPORTANT: The SignWall is already pre-configured for use. All
that is necessary is to connect the hardware as outlined below: