Setup assembly – Smithco Sand Star Zee (ZTR) 45-500-A Operator Manual User Manual
Page 11
9
Introduction
PARTS MANUALS AVAILABLE ONLINE AT smithco.com
SETUP ASSEMBLY
BATTERY BOX
1. Battery box is mounted on the left hand side of the roll
bar.
2. Measure up 5
1
/
2
" from the roll bar mounting plate.
3. Use a u-bolt from the small parts bag to hold the battery
box in place. Tighten all hardware
4. Battery not furnished. Install an automotive type SP 375
cold cranking amps (minimum) battery in the battery box
of the Sand Star Zee. This is a negative grounding sys-
tem. Attach the rubber battery (C) hold-down found in the
small parts bag. Then attach red positive (+) cable (A) to
positive terminal. Slide rubber boot over the positive
terminal to prevent shorts. Attach black negative (-) cable
(B) to the negative terminal.
WARNING! Connecting battery cables to the wrong post
could result in personal injury and/or damage to the
electrical system. Make sure battery and cables do not
interfere or rub on any moving part. Connect the red
positive (+) cable (A) to the battery first. When disconnect-
ing remove the black negative (-) cable (B) first.
FUEL , HYDRAULIC OIL AND GREASE FITTINGS
1. Check engine oil and add as necessary. See engine manual for
recommended motor oil. DO NOT OVERFILL.
2. Fill Gas Tanks with Unleaded 87 Octane gasoline (minimum).
WARNING! Fuel is flammable. Caution must be used when storing or handling it. Do not fill
fuel tank while engine is operating or in an enclosed area. Fumes are explosive and dan-
gerous to inhale. DO NOT SMOKE while filling the fuel tank. DO NOT OVERFILL.
WARNING! The engine and exhaust system become very hot during operation. Rick of burns if
touched. Allow engine and exhaust system to cool before refueling.
3. Check hydraulic oil level on the tank. The
level should be
1-3" from the bottom of the
dipstick. If level is low add Parker Dura Clean
Hydraulic Oil or equivalent of AW32 mini-
mum hydraulic oil.
4. Machine should be greased before starting.
Use general purpose No. 2 lithium base
grease.
A. Rear attachment lift yoke.
B. Right attachment lift mount.
C. Left attachment lift mount.
D. Center attachment lift yoke.
E. Center lift lever.
F.
Front fork.
5. Read operating instructions before starting machine.