325 hydraulic drawing parts list, Installation instructions, Accessories – Smithco Spray Star 1000 (sn 100199 – 100223) Parts & Service Manual User Manual
Page 97
95
Accessories
10-325 HYDRAULIC DRAWING PARTS LIST
REF#
PART#
DESCRIPTION
QUANTITY
1
18-310
11
/
16
x
9
/
16
Straight Thread 90° Elbow
2
2*
10-187
Hydraulic Cylinder
2
14-273
Seal Kit
1 per
3*
10-280
Hydraulic Hose 108"
4
4
34-103
Orbitrol
1
5*
10-284
Hose 28"
1
6
10-279
Hydraulic Hose
1
7*
42-220
Hydraulic Valve
1
42-226
Valve Handle
2
8
10-276
Hydraulic Hose
1
9
18-304
13
/
16
x
3
/
4
x
13
/
16
Straight Thread Run Tee
1
10
10-272
Oil Cooler
1
*
10-325
Hydraulic Lift Kit
INSTALLATION INSTRUCTIONS
1. Shut machine off. Set park brake. Allow system to cool down.
2. Remove the boom lifts from boom and replace with hydraulic cylinder (Ref 2). Use the existing hardware.
3. Refer to the valve drawing for placement of fittings. The valve mounts in the seat panel on the right side.
Use two
1
/
4
- 20 x 2 bolts, washers, lock washers and nuts. Refer to the decal for correct placement.
4. Remove the hose from the top of the oil cooler that comes out of the top of the tee. This hose traces back
to the top of the orbital. Place that hose to the inlet side of the hydraulic valve.
5. Use the short hose 10-284 (Ref 5) to connect the outlet side of the valve to the tee on the oil cooler.
6. Use the four other hoses to connect the valve to the hydraulic cylinders. Refer to the hydraulic drawing.