SONOSAX SX-M2 - Manual (Page 5)

SX-M2 USER MANUAL
BINDER connector is also available.
LEMO in L: Shield = Gnd, Pin 1 = +10V, 2 = +48V, 3 = signal in
LEMO in R: Shield = Gnd, Pin 1 = +10V, 2 = +48V, 3 = signal in
BINDER: Pin 1 = Gnd, 2 = L in, 3 = R in, 4 = +6.2V, 5= +48V
The SX-M2/LS can be used for all condenser or electret microphones having the
possibility of changing the capsules on the microphone body, such as: Colette
series of Schoeps, Blue Line of Sanken, or the similar line of Neumann.
It is important for these kind of microphones to use a good quality active cable.
When buying the cable from a microphone manufacturer, do inform them that the
amplification electronics often used in the cables is not required.
SX-M2M
A very handy feature implemented on this version allows the user to switch the
output of the amplifier on to Mono. The input signal of one Microphone is now
available on both outputs. Using two microphones, a second switch allows to mix
the L+R input to a mono signal which is available on both outputs.
Subject to change without notice
Last update 28/05/99 LG
Back to SX-M2 page
Back to HOME page
Page 5