Spohn LX-604 - Manual

Spohn Performance
,
Inc.
494 E Lincoln Ave Myerstown, PA 17067
1-888-365-6064 www.spohn.net
Part# LX-604 – Adjustable Rear Upper Lateral Arms (Rear Position)
2005+ Chrysler LX, LC & LD
USE OF THIS PRODUCT IS ACCEPTANCE OF SELLER’S DISCLAIMER OF WARRANTY!
By their very nature, competition components are constantly pushed to their limits. While our components are designed
to withstand intense race conditions, it is impossible to control the quality of installation or the varying conditions in
which they are used. It is for this reason that absolutely no warranty or guarantee is either written or implied. Neither the
seller or the manufacturer will be liable for any loss, damage, or injury – direct or indirect – arising from the use of or
inability to determine the use of any product. Before using, the user should determine the suitability of the product for its
intended use, and the user shall assume all responsibility in connection therewith. Spohn Performance, Inc. makes no
guarantee as to the legality for any specific class. Spohn Performance, Inc. makes no claims, nor does it intend its
products to be used in street driven vehicles. Spohn Performance, Inc. reserves the right to make changes in design or
add to or improve on their product without incurring any obligation to install the same on product previously
manufactured. The Buyer agrees to indemnify and hold Spohn Performance, Inc. harmless from any claim, action or
demand arising out of or incident to the Buyer’s installation or use of products purchased from Spohn Performance, Inc.
INSTRUCTIONS
1. With the front wheels securely blocked, raise the rear of the car to an adequate
working height, then support the chassis securely with jack stands leaving the
differential slightly supported with the jack. Place the jack under the rear axle to
support, but do not lift.
2. On the driver's side, remove the wheel and then loosen and remove the bolts from
the knuckle and the cradle securing the stock rear upper lateral arm (rear position).
3. On the driver's side, remove the stock rear upper lateral arm (rear position).
4. On the driver's side, install the Spohn rear upper lateral arm (rear position) on to
the car. Use the factory bolt and nut at the cradle connection and make hand tight
only at this time. At the spindle connection use the factory bolt and the supplied flat
washer and flanged locking nut and make hand tight only at this time. You may need
to use your jack to get proper alignment.
Very Important: Do NOT re-use the factory washer and nut at the spindle
connection. You MUST use the flat washer and flanged locking nut that we
supplied.
5. Repeat Steps 2-4 on the passenger's side.
6. Re-install both rear wheels and then safely lower the vehicle to the ground.
With the vehicle at ride height – suspension loaded:
7. Tighten the mounting bolts at the spindle connection to 72 ft./lbs.
8. Tighten the mounting bolts at the cradle connection to 63 ft./lbs.
9. Our rear upper lateral arms (rear position) shipped jig set at factory length. To
make adjustments you'll note that one end of the adjuster is left hand threaded and
the other end is right hand threaded. To adjust the length of your rear upper lateral
arms (rear position) loosen both jam nuts and put a wrench on the hex in the center
of the adjuster and turn the adjuster clockwise or counter-clockwise to lengthen or
shorten the arm.
1