Sundance SMT365E - Manual (Page 12)

Version 2.1 Page 12 of 26 SMT365e User Manual
Comports
The DSP has six comports, numbered 0 to 5.
The addresses of the Comport registers are described in the SMT6400 help file .
SHB
The SMT365e has six SHB connectors, all of which are connected to the DSP to give
16-bit/32-bit SDB interfaces on two SHB connectors. These interfaces operate with a
fixed clock rate of 100MHz.
Note that the four other SHB connectors are not used.
The following figure shows their localisation on the board:
Global bus
The SMT365e provides a single global bus interface. This is only accessible from the
DSP. The addresses of the global bus registers are shown in the
Virtex Memory Map ,
and are described in the SMT6400 help file .
SDB0 SDB2
SDB1 SDB3
SHB_B SHB_A