Ppp over ethernet (pppoe) mode – Dynalink RTA230 User Manual
Page 67
Chapter 5:Connection Mode
59
PPP over Ethernet (PPPoE) Mode
RDAIUS
Server
AAA
BRAS
STM-1
DSLAM
Loop
Dynamic Public IP
assigned by BRAS
PPPoE+NAT+DHCP
on Private LAN
Hub
ADSL
Router
Ethernet
PC(S)
192.168.1.3
192.168.1.2
PPP over Ethernet
Default Private IP
192.168.1.1
*BRAS: Broadband
Remote Access Server
ISP
(Internet Service Provider)
Description:
In this deployment environment, the PPPoE session is between the ADSL WAN interface and BRAS.
The ADSL Router gets a public IP address from BRAS when connecting to DSLAM. The multiple
client PCs will get private IP address from the DHCP server enabled on private LAN. The enabled
NAT mechanism will translate the IP information for clients to access the Internet.
Configuration:
1.
Start up your browser and type 192.168.1.1 as the address to enter this ADSL web-based
manager.
2.
Go to Quick Setup. Type in the VCI and VPI value. Then click the Next button. eg:
VPI – 0
VCI – 39
3.
On the Configure Internet Connection -Connection Type page, select the PPP over ATM
(PPPoA) then click the Next button.
4.
In the PPP Username and Password page, enter the PPP username and password that you got
from your ISP.
5.
Select Dial on Demand and type in the number for inactivity timeout. The default is 20. Or
select Always on.
6.
In the Configure LAN side Settings page, type in the IP address and subnet mask for your
LAN. Check Enable DHCP Server on the LAN box. And type in the start and end points. Then
type in the leased time that you want. Finally click Next. eg.:
Primary IP address:192.168.1.1
Subnet Mask:255.255.255.0
Start IP Address:192.168.1.2
End IP Address: 192.168.1.254
7.
Check the network information. Make sure the settings match the settings provided by ISP.
Click Finish.