Dometic RM660 - Manual (Page 12)

INSTRUCTIONS FOR MOUNTING THE DOOR PANEL
The refrigerator is normally delivered without door panel(s).
Before starting the mounting work check that the panel di-
mensions are in compliance with those given in the table and
read the instructions through. When mounting the panel, pro-
ceed as follows.
A.
B.
C.
D.
E.
F.
Remove the top decoration strip (2) with its two screws
(1).
Insert one of the vertical edges of the panel into the
groove of the door frame (3).
Bend the panel gently so that the free side of the panel
can be slipped into the corresponding groove of the door
frame (4).
Push the panel downwards so that the lower horizontal
edge of the panel is fitted into the bottom groove (5).
Between the upper edge of the panel and the door frame
there is now a gap which should be covered by the de-
coration strip.
Put the strip across the door so that the gap is covered
and push it upwards (6).
The tabs on the inside of the strip should fit in behind
the flange of the door frame. Secure the decoratlon strip
by means of the two screws (1).
Panel dimensions
Thickness max. 5/32”
TYPE
RM 360
RM 460
RM 660
RM 760
upper
RM 760
lower
RM 1300
upper
RM 1300
lower
T
L
HEIGHT
MAX. MIN.
636
25”
679
26 23/32
879
34 5/8
288
11 11/32
633
24 7/8
676
26 19/32
876
34 1/2
285
11 7/32
801 798
31 17/32 31 13/32
360 357
14 3/16 14 1/16
879
34 5/8 876
34 1/2
WIDTH
MAX.
516.5
20 11/32
550.5
21 11/16
550.5
21 11/16
550.5
21 11/16
550,5
21 11/16
598.5
23 9/16
598.5
23 9/1 6
MIN.
513.5 mm
20 7/32 inch
547.5 mm
21 9/16 inch
547.5 mm
21 9/16 inch
547.5 mm
21 9/16 inch
547.5 mm
21 9/16 inch
595.5 mm
23 7/1 6 inch
595.5 mm
23 7/1 6 inch
HK-M 7937 820 47 96
FPC 119 RM-3-4-6-7-13