Teac K-05X - Manual (Page 26)

26
Clock sync mode setting
Display: CLK>***
o This setting can be made for each input.
o During COAX or OPT input, input a clock that is synchronized
with the input source. If the source device does not support clock
input, set this to OFF.
o During USB input, the clock frequencies that can be input depend
on whether the playback file is 44 .1 kHz or 48 kHz. 10MHz clock
can be input for any type of playback file.
OFF
No clock sync is used.
SYNC
This unit's master clock is synchronized to the clock signal (44.1 kHz,
48 kHz, 88.2 kHz, 96 kHz, 176.4 kHz, 192 kHz or 10 MHz) input
through the CLOCK SYNC IN connector and used for operation.
MCK
The 22.5792MHz/24.576MHz signal input through the CLOCK
SYNC IN connector is used as the master clock.
Analog output setting
Display: AOUT>***
XLR2
Analog audio signals are output through the XLR connectors with
pin 2 HOT.
XLR3
Analog audio signals are output through the XLR connectors with
pin 3 HOT.
RCA
Analog audio signals are output through the RCA connectors.
OFF
Analog outputs are disabled and the D/A converter is turned off.
Digital output setting
Display: DOUT>***
o The signal is output without upconversion.
o During Super Audio CD playback, this is automatically set to off.
OFF
Turns the digital output off.
ON
Turns the digital output on.
CD digital audio is output during disc playback.
During COAX or OPT input, the input signal is output as is.
During USB input, a digital signal is output only during playback of
PCM files.
During DSD file playback, a digital signal is not output.
Automatic display (FL) off setting
Display: DPaOFF>***
ON
If playback is stopped and no operation is conducted for 30 min-
utes, the display automatically turns off.
OFF
The display never turns off automatically.
o If the display is left on with the same indication for a long time,
brightness irregularities can occur. For this reason, we recommend
that you set the automatic display off function to ON.
Setting items and their options (continued)