Teac KS-6002 - Manual (Page 4)

4
KS-6002 EQ Compressor
sible that either the KS-6002 or the other unit(s) will be dam-
aged.
In the event that smoke or odors come from the unit, turn off
the power and remove all batteries and external power supply
sources at once. Contact your dealer or service representative.
In the event of damage or injury caused by accidents, improper
operation or functioning, the proper course of action shall be
determined according to our service regulations. Please note
that we cannot be responsible in any way for any loss of pre-re-
corded material.
Side view
+ - + - + - + -
Unit release
lever
THRESHOLD
LEVEL controls
The KS-6002 unit has the following features when viewed from
the left side:
Unit release lever:
There is a corresponding lever on the right
side of the unit. Slide these levers to the RELE. position when
attaching and detaching the KS-6002 to and from another unit
mounted above the KS-6002 (e.g. a KS-6001 sub-mixer). Leave
this lever in the LOCK position when the KS-6002 is attached to
the KS-6001 or the other unit.
When using the KS-6002 with the KS-342 or another unit at-
tached below the KS-6002 using the bottom connectors, use
the unit release levers of the other unit, not those of the KS-
6002, to attach and detach the KS-6002.
NOTE
The KS-6002 always should be placed above at least one other
Kamesan unit when fitted in a stack of such units. Although
some such units have retractable connectors, the KS-6002 lower
connector cannot retract, and there is therefore a danger of
damage if it is left protruding below the unit. You should also note
that there is also a plate on the top surface of the KS-6002 which
can be removed and used to connect the KS-6002 to other