Teletronics EZBridge AP - Manual

002
2503500500
Donald^^11
Quick Installation
This guide is for you to make a connection between
wired and wireless network. You will learn how to
install the Access Point on your network step by step.
If you have any problems during the installation,
please refer to your User Manual.
Introduction
Congratulations on the purchase of your new access
point. The access point is compliant with the IEEE
802.11b (DSSS) specifications. Small as the sparrow
is, it possesses all its internal organs.
Notebook P C
WA1300 Access Point
Mac II
Notebook Notebook
Figure 1: Network Connection
Package Contents
The following items should be included:
a) One Access Point Unit (the device).
b) One Power Adapter.
c) One User’s Manual.
d) One Quick Installation Guide.
If any items listed above are damaged or missing,
please contact your dealer immediately.
System Requirements
a) One or more PCs (desktop or notebook) with
Ethernet interface.
b) TCP/IP protocol must be installed on all PCs.
c) Network cables. Use standard 10/100BaseT
network (UTP) cables with RJ45 connectors.
d) All w ireless devices must be compliant with the
IEEE 802.11b specifications.
e) Microsoft Internet Explorer 5.0 or later or
Netscape Navigator 4.7 or later.
Installing Your Access Point
Take Windows 98 platform for example
Figure 2: Installation Diagram
Installation Instructions
a) Use straight LAN cable to connect the Access Point
with a hub of the wired network.
b) Connect the power adapter to the power jack on the
Access Point.
The Power LED (the right one) should be on when the
power adapter is connected.
c) Use straight LAN cable to connect the PC with the
wired network.
d) Power on one of the PCs and login if you are asked to.
When you reach the desktop, click Start on the
taskbar, select Settings , and then select Control
Panel.
e) Double-click the Network icon to open the Network
dialog box as below.
Figure 3: Network Configuration
f ) Select the TCP/IP protocol for your network card.