Teletronics EZBridge AP User Manual
Page 2
002
2503500500
o)
Click Properties. You will then see a dialog box
shown below .
Figure 4: IP Address
p)
Ensure your TCP/IP settings are correct as
follows.
To use static IP address, select Specify an IP
address. Type 192.168.1.200 in the IP address
field and 255.255.255.0 in the Subnet Mask field.
The IP address must be 192.168.1.x. The value of x
should be ranged from 1 to 254 and is never used
by other PCs.
q)
Click OK again. Windows may copy files to your
computer, and then you will be asked to restart
your PC. Click Yes to restart your computer and
initiate the new settings. If you aren’t asked,
manually restart the computer to ensure the
system has used the IP address you just
specified.
r)
Open
your
Web
browser
and
type
“HTTP://192.168.1.90” in the Address field.
Then press Enter.
Figure 5: Enter Web Address
s)
A logon dialog box will appear. The default User
Name is root and Password is root. Put User
Name and Password and Click OK.
Figure 6: User name/Password Dialog Box
t)
After you click OK, the Setup screen is shown
like the following figure.
Figure 7: Setup Screen
g)
Click the Configuration tab and type texts in the
Network name field, wirelesslan, for example.
After setting the Network name, click Save,
Reboot, and then OK.
The Configuration screen is shown as the following
figure.
For the purpose of security, you can enable the WEP
function. Follow the steps below (take 64 bit encryption
for example):
h)
Click the Encryption tab, and then select the
WEP enabled function.
i)
Choose 64 bit on the right side of the WEP key
lengths field. Type 10 hex digits into the key box
at the right of the WEP key 1 field.
j)
Choose Key 1 on the right side of the WEP key
to use field.
k)
Select the Deny unencrypted data option.
l)
Choose Shared Key in the Authentication field.
m)
Click Save, Reboot, and then OK in sequence.
n)
The Configuration screen is shown as the
following figure.
Once you have configured all of the PCs on your
network with appropriate values of Network name and
WEP key, the access point setup and installation are
complete.
For instructions on MAC address filtering or other
advanced configurations, refer to your User Manual.
2503501200