Teletronics EZBridge Station Bridge User Manual
Page 2
g)
Click Properties. You will then see a dialog box
shown below .
Figure 4: IP Address
h)
Ensure your TCP/IP settings are correct as
follows.
To use static IP address, select Specify an IP
address. Type 192.168.1.200 in the IP address
field and 255.255.255.0 in the Subnet Mask field.
The IP address must be 192.168.1.x The value of x
should be ranged from 1 to 254, except 99, and is
never used by other PCs The default IP of
Station/Bridge is 192.168.1.99.
i)
Click OK again. Windows may copy files to your
computer, and then you will be asked to restart
your PC. Click Yes to restart your computer and
initiate the new settings. If you aren’t asked,
manually restart the computer to ensure the
system has used the IP address you just
specified.
j)
Open
your
Web
browser
and
type
“HTTP://192.168.1.99” in the Address field.
Then press Enter.
Figure 5: Enter Web Address
g)
A logon dialog box will appear. The default User
Name and Password are both root.
Figure 6: User name/Password Dialog Box
k)
After you click OK, the Setup screen is shown
like the Figure 7.
Figure 7: Setup Screen
m)
Click the Configuration tab and enter texts in the
Network name field, wirelesslan, for example.
After setting up Network name , click Save,
Reboot, and then OK in sequence. The
Configuration screen is shown as the following
figure.
Figure 8: Configuration Screen
For the purpose of security, you can enable WEP
function. Follow the steps below (take 64 bit encryption
for example):
n)
Click the Configuration tab, and then select the
WEP enabled function.
o)
Choose 64 bit on the right side of the WEP key
length field. Type 10 hex digits into the key box at
the right of the WEP key 1 field.
p)
Choose Key 1 on the right side of the WEP key
to use field.
q)
Select the Deny unencrypted data option.
r)
Choose Shared Key in the Authentication field.
s)
Click Save, Reboot, and then OK in sequence.
Once you have configured all of the PCs on your
network with appropriate value of Network name and
WEP key, the Station/Bridge setup and installation are
complete.
For instructions on other advanced configuration, refer
to your User Manual.
2503501000