Teletronics EZBackhaul - Manual (Page 18)

Grounding
The EZBackhaul is shipped with a grounding wire. The unit must be properly grounded to protect
against power surges. The EZBackhaul grounding point can be found on the bottom of the unit. It is
supplied with an appropriate grounding lug for attachment to the ODU.
Figure 7 Grounding
Power On
To power up the EZBackhaul, follow the steps bellow:
1. Plug a user-supplied Cat-5 Ethernet cable from your wired LAN (or a computer) into the power
injector RJ-45 jack (NET);
2. Plug a user-supplied Cat-5 Ethernet cable from the EZBackhaul into the power injector RJ-45 jack
( ODU);
3. Connect the power module to the power injector and plug the AC cord into an AC power
receptacle;
4. After being powered on, the device will send out the beep sound lasting about 1.5 seconds,
informing you that the EZBackhaul is powered up! Wait for about 60 seconds the system will be
initialized and start working!
Page 18
Warning:
Make sure PoE is correctly connected to the RJ-45 port on the EZBackhaul labeled
PoE+ NET, otherwise the extender will be severely damaged!